![]() ![]() Input name - Change the name of the input. ![]() Make sure to press the Save action button if you’re editing or creating an action. Overview - displays the sensor’s readings (the temperature). You can send internal or external urls, which means you can send urls to this device, or to another device. Then do - Using urls and local actions, specify what you want the device to do when the condition is met. You can choose less than or greater than a certain value to make the action occur when the temperature drops below or rises above the value depending on what you choose. When creating an action, there are a few things you will be asked to specify:Īctive time - A period of time in the 24 hours of the day that the action is allowed to be triggered.Įxecute when - Only after a temperature change, or every 60 seconds.Ĭondition - Specify when you’d want the action to occur. Humidity Offset - A value, which will be added (if positive) and subtracted (if negative) from the humidity readings to make them more accurate.Ĭreate and edit actions. The minimum is 1% and the maximum is 20%. Humidity Delta Threshold - Relative Humidity change with more than the specified value triggers sensor data report. Temperature Offset - A value, which will be added (if positive) and subtracted (if negative) from the temperature readings to make them more accurate. The minimum is 0.1℃ and the maximum is 5℃. Temperature Delta Threshold - Temperature change with more than the specified value in Celsius triggers sensor data report. ![]() Name - Set the peripheral’s name, which you’d like it to be displayed with. You can access them by clicking on the peripheral in the Add-on menu. Removing and adding a peripheral requires a device reboot.Įach peripheral has a unique set of settings, explained below. You can add it again, but you cannot retrieve the actions or the customised settings you may have had before. There is a Remove button above each peripheral, which will remove the peripheral and all of its actions. It should look similiar to the image below, except instead of the temperature sensor and voltmeter, your added peripherals should be displayed in this page. If you have successfully added all of your peripherals, your Add-on menu should display them. A message notifying you if your device needs to reboot will pop up on the top part of your screen with a Reboot button. Click on the peripheral and click the Save settings button.Īdding or removing a peripheral requires the device to reboot. If you have properly connected your peripheral(s) and have selected the correct type of peripheral from the menu that pops up, your peripheral will appear under the menu under Found peripherals. You will then be prompted to pick the type of peripheral you’d like to add. ![]() Adding PeripheralsĪdding peripherals is done by going to the Add-on setting in the web UI of your Plus device and clicking the Add Peripheral button. For more information about the device itself, you can see the Add-on device page and the installation guides linked at the end of it. Under the Add-on setting, you can add your Add-on so you can control it. To get started with using the Shelly Plus Add-on and the settings inside of its embedded web interface, you will need to, after you have properly installed the device and connected it to your Plus device, add it through the web interface of your Plus device. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |